AC Repair Services › AC Unit Installation Service
AC Unit Installation Service in Richardson, TX
Installation means pulling out the old equipment and putting in new equipment that's matched to your home's actual load — not just whatever's closest in size to what came out. A system that's too large short-cycles and leaves humidity problems. One that's too small runs constantly and never catches up. Getting the size right is the first job.
Richardson AC Repair Pros provides AC unit installation service for homeowners across Richardson, TX. Call for a free inspection and a written quote before any work begins.
When to Call
When You Need AC Unit Installation Service
- Your current system is over 15 years old and repairs are becoming frequent.
- The compressor failed and repair cost approaches what a new system would cost.
- You bought a home where the existing unit is undersized for the square footage.
- You're finishing a bonus room or addition that the current system can't serve.
- Your utility bills have been climbing steadily even though usage hasn't changed.
- The refrigerant type in your old unit is no longer widely available or affordable.
How It Works
Our Process for AC Unit Installation Service
- 1
Load calculation
We measure the conditioned space, check insulation levels, window count, and orientation. This tells us the correct equipment size before we recommend anything.
- 2
Equipment selection
We match the outdoor condenser and indoor air handler to each other and to your load number. We explain the tradeoffs between efficiency tiers in plain terms.
- 3
Old equipment removal
We recover refrigerant from the old system properly, disconnect electrical, and remove both the indoor and outdoor units. The pad and disconnect are evaluated for reuse.
- 4
New system installation
Lineset is inspected and replaced if needed. We set the outdoor unit level, make electrical connections, and install the air handler with proper drain configuration.
- 5
Startup and commissioning
We pull a vacuum on the refrigerant circuit, charge to manufacturer spec, and verify airflow, static pressure, and temperature split before we leave.
- 6
Walkthrough with homeowner
We show you the new equipment, explain the filter location, and walk through the thermostat settings. You should know what's in your home before we close the truck.
What's included
- Manual J load calculation to determine correct system size for your home.
- Removal and disposal of existing indoor and outdoor equipment.
- New condenser, air handler, and refrigerant line set as needed.
- Electrical connections at the unit and disconnect box.
- Full system startup, vacuum, charge verification, and airflow testing.
- Homeowner walkthrough explaining the new equipment and filter schedule.
What's not included
- Ductwork repairs or replacement — existing duct condition is assessed separately.
- Electrical panel upgrades if your current panel can't support the new equipment.
- Permits if required by the city — we'll tell you upfront if your job needs one.
Real Situations
Common Scenarios in Richardson
A homeowner in Richardson's Springpark area has a 17-year-old system where the compressor just failed on the hottest week of July.
We walk through the age and repair history honestly. If the compressor is the only failure, we give a real comparison between compressor replacement and a new system — including what the older system is likely to do over the next two years.
A couple who recently bought a 1980s ranch home on Breckinridge finds the single system struggles to cool the back bedrooms.
We do a proper load calculation rather than just swapping in the same size. Sometimes older homes were under-equipped from the start. We also check duct condition because leaky ducts in older homes can cause just as many problems as the wrong equipment.
A homeowner adding a 400-square-foot sunroom wants to know whether their existing system can handle the added load.
We recalculate the total load with the addition included. Often the existing system can't handle it. We discuss options — a mini-split for the addition only, or a full system upgrade — depending on what makes sense for their situation.
Richardson Context
Why this matters in Richardson
Richardson has a lot of single-story brick homes from the 1970s and 1980s with original duct systems in the attic. Attic temps here can hit 140 degrees in summer, which shortens equipment life and stresses duct seams. Choosing equipment that matches the actual load matters more here than in milder climates where an oversized system can get away with more.
Straight Talk
About pricing & scope
Installation cost depends on equipment efficiency tier, whether the lineset needs replacing, and any electrical work the new equipment requires. We won't know everything until we're on-site and can assess the existing infrastructure. If something comes up mid-install — like a lineset that's corroded or undersized — we'll stop and explain before continuing.
What This Fixes
Problems We See in Richardson
More AC Repair Services